Fabric Care: Washing
- Make sure detergent is completely dissolved in the water before adding clothes.
- To keep dark colors from fading, wash only in cold water.
- To minimize wear and tear we strongly suggest to turn garments inside out.
- Make sure zippers are closed on all garments before washing.
- If needed pre-treat spots with a fabric safe stain remover before washing.
- Never use chlorine bleach.
Logo Design & Zipper Care
- Printed vinyl logos must not be ironed. Heat from the iron will melt or damage the logo.
- Sew on logo may be ironed, but on low heat iron setting. High heat from the iron might damage the
embroidery.
- For best results, turn garment inside out - that will also prevent a zipper from scratching.
Fabric Care: Dry & Iron
- Since heat is the major cause of fading and shrinking, do not use highest heat of dryer on any fabrics.
- Do not over dry garments. It is better to hang up items to finish drying rather than over drying your
garments.
- Never wash garments with towels since this may cause the fabric to pill.
100% cotton has tendency to shrink. Hang dry or tumble dry on low if recommended on care instructions.
- Iron on a low temperature setting.

®
Model Copyright © 2011 I'M NOT A MODEL ® All rights reserved. I'M NOT A MODEL ® is a REGISTERED trademark. info@imnotamodel.com THE OFFICIAL I'M NOT A MODEL ® BRAND WEBSITE
Online Shopping is offered to
customers WORLDWIDE.
I'M NOT A MODEL ® corporate
headquarters are located in the
United States.
All prices in USD.